Use and Care Manual

Installation

Hardware List

Table top

Table base

Table leg

Support frame

Connecting piece

8x16mm screw

Washer

Foot pad

spare 4x15mm Self-tapping

screws

Hexagonal screw tap

Step 1

Use 8x16mm screws and connecting piece to connect the two table legs. Be

careful not to fully tighten the screws first, wait until step 3 is completed.

PAGE 1
Installation Hardware List Hardware List 1 Table top 1 Table base 2 1 Table leg Support frame 1 Connecting piece 26 8x16mm screw 20 6 Washer Foot pad spare 4x15mm Self-tapping 8 1 Hexagonal screw tap screws Step 1 Use 8x16mm screws and connecting piece to connect the two table legs. Be careful not to fully tighten the screws first, wait until step 3 is completed.
PAGE 2
Step 2 Use 8x16mm screws to fix it first, be careful not to fully tighten the screws, wait until step 3 is completed. Step 3 Screw the foot pads onto the table base (you can adjust the balance through the foot pads when the ground is uneven) Fix the table base with 8x16mm screws. Then tighten all the screws from the previous steps.
PAGE 3
Step 4 Put the table top on the table leg, make sure the reserved screw holes of the table top and the frame are corresponding, tighten 8x16mm screws to finish the installation. This is a spare screw hole. When the 8x16mm screw fails to be screwed in, the hole can be fixed with a 4x15mm self-tapping screw. Either way will do.