Use and Care Manual

6
Ø Wall Mounting Instructions
** It is recommended to complete the following procedure with at least 2 people **
Tools Required
Tools and parts
required for Plaster
and or Wood
Installation
Drill & Drill Bit
1
Phillips Head Screw Driver
1
Wood screws 2” long
4
Wall Mounting Kit Includes the following:
Description
Wall Hanging Bracket
2
Wall Hanging Hook
2
Plastic Spacers
2
Exhaust Pipe
1
a)
Determine the position where you will be installing the mounting bracket.
(This dryer is not designed to sit directly on top of your washing machine).
(A minimum of 2 inches in required between the top of the dryer and the ceiling to allow easy
installation and adequate space for exhaust).
(If mounting above a washing machine, allow sufficient spacing to open the lid of the washer or
breathing room in the case of a front-loading washer).
b)
c)
Affix the wall mounting bracket (included)
securely to the wall (directly to the stud).
(If a stud is not available, use a wooden slat
between the studs to mount the bracket)
Install the Wall Hanging Hooks as shown in
illustration (Fig. 2).
Fig 2:
d)
Install the exhaust pipe as shown in
illustration (Fig. 3). (Align the Exhaust pipe
to the Exhaust Vent and turn Clockwise)
• The exhaust vent can be locked into the
position that best fits your needs.
(Upward, Downward or venting to
either side left or right).
Fig 3:
e)
Mount the dryer on the wall bracket as
shown in illustration (Fig. 4).
** It is recommended that this step be done
by two (2) or more persons **
Fig 4: