Installation Guide

• The location must be large enough to allow the washer door to be fully opened� The door opens more than

90°, and is not reversible�

• Additional spacing should be considered for ease of installation and servicing�

• Minimum spacing of 1” (25 mm) on all sides of the washer is recommended to reduce noise transfer�

• Additional clearances might be required for wall, door, and floor moldings�

• Spacing for companion appliance should also be considered�

Figure 3

Figure 4

INSTALLATION

CAUTION: Packing materials may be dangerous to children�

Please dispose them properly and DO NOT let children play with

any packing materials�

Before using this washing machine, transport bolts must be

removed from the backside of this machine� Please take the

following steps to remove the bolts:

1� Loosen all bolts and then remove them�

2� Insert the transport hole plugs into the holes�

3� Keep the transport bolts for future use�

Make sure that the small foam triangle is removed with the bottom

foam piece� If not, carefully lay the unit down and remove it�

When you unpack your washing machine, check if there is any

damage or missing pieces� If any items missing, please contact

customer service�

LEVELING THE WASHER

1� When positioning the washing machine, make sure the

legs are screwed in close to the cabinet� If not, turn them

to their original positions by hand or with a wrench and

tighten the nuts with a wrench�

2� After positioning the washing machine, push on all four

corners at the top of washing machine� If the washing

machine has any wobble, or is not stable when being

pressed, adjust the leg to level the machine�

3� To level the unit, loosen the lock nut with a wrench and

turn the leg by hand until it tightly contacts with the floor�

Press the leg with one hand and tighten the locking nut

close to the cabinet with the other hand�

4� Repeat steps 2 and 3 as needed�

5� Use a bubble level to check front to back, side to side, and

corner to opposite corner to ensure the washing machine

is level� Repeat above steps if needed�

Figure 5

Figure 6