Installation Guide

ManualsBrandsMagic Chef ManualsAppliances24 in. 2.7 cu. ft. Front Load Compact Washer in White

TROUBLESHOOTING

ALARM CODE DETECTION

Alarm Code Cause of Problem Solution

E30 Door is not properly closed�

Check if clothes are stuck in door�

Close door and restart�

E10 Problem with water flow�

Check if the water pressure is too low�

Make sure inlet hose is not bent or blocked�

Check if the inlet valve filter is blocked�

E21 Water taking too long to drain� Check if the drain hose is blocked�

E12 Water overflow� Restart the washer�

EXX Other Restart machine to clear� Call customer service if code persists�

NOTE: After trying the solution, restart the washing machine� If code persists, contact customer service�

When the washing machine needs servicing, please contact our customer service department, and a representative

will try to diagnose the issue� Please do not dismantle the washing machine without prior permission� Doing so

will void your warranty�

If the washing machine fails to operate properly, or it sounds an alarm, please check the following guidelines for

possible solutions to common problems or alarm indicators�

LIST OF PROBLEMS AND POSSIBLE SOLUTIONS

Problem Cause Solution

Washing machine

will not start �

Check if the door is closed tightly�

Check if power plug is properly inserted�

Check if water supply is open�

Check if “On/Off” button is pressed�

Check if “Start/Pause” button is pressed�

Door cannot be opened� Safety lock is engaged� Disconnect the power�

Heating fault

NTC thermistor is damaged and

heating pipe is worn�

Contact customer service�

Water leakage

The connection between inlet

pipe or outlet hose and tap or

washing machine is not tight�

Check and fasten water pipes�

Drain pipe is blocked� Clean up outlet hose and drain�

Water overflowing from

the bottom of the

Machine

The inlet pipe is not connected

firmly�

Fix the inlet pipe�

Outlet hose has water leakage� Replace the drain hose�

Indicator or display do

not light�

Power is disconnected� Check if plug is connected correctly and power is on�

PC board has problems�

Contact customer service�

Harness has connection problem�