Installation Guide

3� Remove the inlet pipe and immerse it in warm water�

4� Pour warm water into washing drum and wait for 10 minutes�

5� Reconnect inlet pipe to the tap and check whether inlet and outlet are working normally�

NOTE: when the washing machine is reused, make sure the ambient temperature is above 32 °F (0 °C)�

TO PREVENT FREEZING

If your washing machine is located in the room where it can get frozen easily, please drain the remaining water

inside drain pipe and inlet pipe thoroughly�

Remove the remaining water in inlet pipe:

1� Close the tap�

2� Screw off the inlet pipe from tap and put its end into the

container�

3� Start up any procedure except single Wash or Drain

procedure� Water will be drained out of inlet pipe if any

for about 40 seconds�

4� Reconnect the inlet pipe to tap�

EMERGENCY DOOR RELEASE

In the case of a power failure or other circumstances and door

cannot be opened, if it is necessary to open the door, pull down

on the cord inside the access panel� Be sure to restore the pull

cord after opening the door�

CAUTION: The emergency switch pull cord cannot be used

during washing� If unit is in operation, wait for it to stop and for

the interior to cool to a safe temperature before opening door�

Figure 23

Emergency

Door

Pull Cord