Installation Guide

PARTS AND MATERIALS
TOOLS THAT MAY BE NEEDED
MATERIALS THAT MAY BE NEEDED
• Hot Water Supply Line – Min. 3/4” O.D. copper
tubing or metal braided dishwasher supply line
• UL listed conduit connector or strain relief.
• Teflon tape or pip thread compound to seal
plumbing connections.
• Shut-off valve and fittings appropriate for hot
water supply line (copper tubing/compression
fitting, or braided hose)
• Silicone
• Glue
INCLUDED PARTS AND MATERIALS
• Slot Screwdriver
• Phillips Screwdriver
• Drill
• Wire Stripper
• Pipe Wrench
• Hole Saw
• Tape Measure
• Adjustable Wrench
• Level
• Wire Cutter
• Hammer
• Torx Screwdriver
• Brush
• Scissors
• Pencil
6
a.
b.
c.
d.
e.
f.
g.
h.
i.
j.
k.
l.
m.
n.
The parts required for installing the dishwasher are in plastic bags. Check that all of the following parts are
contained in plastic bags.
b.
c.
d.
e.
Steam Protection Foil x 1
Side Trim Strips (Left) x 1
Side Trim Strips (Right) x 1
f.
g.
h.
Screws 0 5/32" x 19/32" (0 4mm x 5mm) x 2
Mounting Bracket Left x 1
Mounting Bracket Right x 1
i.
j.
k.
l.
m.
n.
Toe Kick Bracket x 2
Screws 5/32" x 7/32" (4mm x 6mm) x 1
Plinth Fixing Bracket x 4
Adjustable Plinth x 6
Metal Toe Kick (80mm) x 1
Plinth Locking Pin x 2
Long Legs x3
DISHWASHER PARTS BAG 3
DISHWASHER PARTS BAG 1
a. Hose Clamp x 1
DISHWASHER PARTS BAG 2
DISHWASHER PARTS BAG 4 (MODEL DEPENDING)
DISHWASHER PARTS BAG 5 (MODEL DEPENDING)