Instructions / Assembly

CONNECTION TO WATER OUTLET (WITH OPTIONAL DRAIN HOSE)
In products with a condenser unit, water accumulated in the water tank during the drying process. The
water tank must be emptied after each drying process. Alternatively, you can use the included water drain
hose to drain the water directly into a sink or floor drain.
CONNECTING THE WATER DISCHARGE HOSE
1. Pull out the end of the hose at the back
of the dryer. Do not use any tools or
sharp objects to take out the hose. (a)
Figure 3
a
b
c
2. Fit one end of the included water
discharge hose into the slot from which
you have removed the hose. (b)
3. Fix the other end of the water discharge
hose directly to floor drain or sink. (c)
ATTENTION: The hose must be
connected in a manner that it cannot easily
fall out or be removed. If the hose comes
out during water discharge, flooding may
occur.
IMPORTANT: The water discharge
hose must be installed at a maximum
height of 31.5” (80 cm).
IMPORTANT: The water discharge hose must not be bent, folded or crimped between the outlet
and the product.
10
ELECTRICAL CONNECTION
ATTENTION: Risk of fire and electric shock.
• Your dryer is set to 208-240 V and 60 Hz.
• The mains cable of the dryer is equipped with a NEMA
14-30P / 30A,125V/250V plug. This plug must be connected
to an properly grounded socket protected by a fuse of 16
Amperes as indicated on the type plate. The fuse current
rating of the power line where the outlet is connected must
also be 16 amperes. Consult a qualified electrician if you do
not have such an outlet or fuse.
• Our company cannot be held responsible for damages
resulting from usage without earthing.
4-
Wire Receptacle
(14-30R)
Figure 4
IMPORTANT: Operating your machine at low voltage values will shorten the service life and decrease
the performance of your dryer.