Owner Manual

3
GROUNDING INSTRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding plug reduces the 
risk of electric shock by providing an escape wire for electric current. This appliance is equipped with a 
cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is 
porperly installed and grounded.
WARNING: Improper use of the grounding can result in a risk of electric shock.
Consult a qualified electrician or serviceman if the grounding instructions are not 
completely understood, or if doubt exists as to whether the appliance is properly 
grounded, and either:
(1) If it is necessary to use an extension cord, use only a 3-wire extension cord that 
has a 3-blade grounding plug, and a 3-slot receptacle that will accept the plug on 
the appliance. The marked rating of the extension cord shall be equal to or greater 
than the electrical rating of the appliance, or
(2) Do not use an extension cord, if the power supply cord is too short, have a qualified 
electrician or serviceman install an outlet near the appliance.
FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
(U.S.A ONLY)
WARNING: 
This equipment generates and uses ISM frequency energy and if not installed and used properly, 
that is in strict accordance with the manufacturer's instructions, may cause interference to radio and 
television reception.
It has been type-tested and found to comply with limits for an ISM equipment pursuant to part 18 of 
FCC rules, which are designed to provide reasonable protection against such interference in a 
residential installation.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause interference to radio or television reception, which can be determined 
by turning the equipment off and on, the user is encouraged to try correct the interference by one or 
more of the followings.
• Reorient the receiving antenna of radio or television.
• Relocate the microwave oven with respect to the receiver.
• Move the microwave oven away from the receiver.
• Plug the microwave oven into a different outlet so that microwave oven and receiver are on 
different branch circuits.
THE MANUFACTURER is not responsible for any radio or TV interference caused by 
UNAUTHORIZED MODIFICATION to this microwave oven. It is the responsibility of the user to 
correct such interfercnce.
CNA_MCD1311ST_R-1B4H0A(영).indd 3 15. 4. 21. 오전 9:31










