Installation guide

To Convert Surface Burners
v1
10.
12
Remove grates from cooktop
Lift the cooktop by both front corners until the side support
rods snap into position.
Remove the screws that hold each dual burner.
A. Dual burner screws
Lift each burner and slip it back to remove it.
Set them aside.
Locate LP gas orifice spuds for top burners in the bag
containing literature included with the range. Four LP gas
spuds are stamped “67.”
Remove Natural gas orifice spuds from the valve using a
¥%8" (0.95 cm) combination wrench.
Install LP gas orifice spuds in the valves.
A. Orifice spuds
B. Valves
Place the Natural gas orifice spuds in the parts bag for future
use and keep with the bag containing literature.
Replace grates.
To Convert Oven Burner
1. Open the oven door and remove oven racks, oven tray, flame
spreader and set aside.
2. Lift oven burner. The orifice spud is behind the oven burner
air shutter.
A. Air shutter
3. Locate LP gas orifice spud stamped “56” in the bag
containing literature supplied with the range.
4. Use a %" combination wrench and remove the Natural gas
orifice spud.
5. Install the number “56” LP gas spud.
A. LP oven orifice spud stamped with “56”
IMPORTANT: Do not overtighten.
6. Place Natural gas oven burner spud in plastic parts bag along
with Natural gas cooktop burner spuds for future use and
keep with the bag containing literature.
7. Reinstall oven burner.
8. Reinstall oven racks, oven tray and flame spreader.