Installation guide

Connect wires black to black and white to white, using UL
Listed/CSA Approved twist-on wire connectors (not included).
Wiring configuration
Power supply wire: Terminal box:wire:
white <-> white
black «<«—_—»-. black
ground wire -<¢—_—»» ground connector
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/electrical under FAQ tab.
4 | Direct Wire—Secure cable
r— in strain relief
Tighten strain relief screws to secure cable.
Direct Wire—Reinstall
terminal box cover
a
Place wires inside terminal box. Insert tabs on left side of cover.
Make sure wires are tucked inside box. Close cover ensuring
wires are not pinched. Use 4" nut driver and previously removed
screw to secure cover.
18
oo ee
Double-check dishwasher
alignment in cabinet opening
Check that dishwasher is still level front-to-back and side-to-side in
cabinet opening.
IMPORTANT: If you have solid countertops such as Corian*', granite,
etc., you must use side mounting kit (Part Number 8212560). Follow
kit instructions. (Brackets included with kit.)
Remove lower dish rack
and place towe
7 cere oesray
“9 RR oa
Open dishwasher door, remove lower dish rack, and place towel over
pump assembly and lower spray arm of dishwasher. This will keep
screws from falling into pump area when you are securing dishwasher
to countertop.
NOTE: Do not drop screws into bottom of dishwasher.
Locate brackets on top of dishwasher and secure dishwasher to
countertop with two, #10 x %" Phillips-head screws (included). The
dishwasher must be secured to keep it from shifting when door is
opened.
t®Corian is a registered trademark of E.l. Du Pont De Nemours and Company.