Installation guide

10 Check level side to side and
i
Na
REN
eel
ed
INNO
Ziss
Place level against top front opening of tub. Check that
dishwasher is level from side-to-side. If disnwasher is not level,
adjust front legs up or down until dishwasher is level.
"pin, yy pp xy, pointe Oe git, “YD Y gpouglle
Connec! io Wate
Lo SS
PG ee
\7 :
NN
J
Be sure rubber washer is properly seated in fitting. Slide the 9%"
fitting up to the valve and hand tighten to avoid cross-threading.
Hand tighten until the coupling is tight.
Using pliers, check the tightness of the coupling. An additional %
to % turn may be required to seal the rubber gasket.
NOTE: Do not overtighten. Damage to the coupling can result.
Check for leaks
Place paper towel under 90° elbow fitting. Turn on water supply
and check for leaks. If leak occurs, repeat previous step.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/watersupply under FAQ tab.
NOTE: Do not use Teflon®' tape with compression fittings.
T®TEFLON is a registered trademark of E.I. Du Pont De Nemours and Company.
16
we
* 5 sexy stn, ar ey gin, he Tam sn
Connect io Drain a
1 Connect drain hose
Green clamp
Black drain hose
connector
Place towel under drain hose to catch any water in drain hose.
Place the small green drain hose clamp onto the small end of the
drain hose. Push the new drain hose into the black drain hose
connector up to the drain hose stop.
Green clamp
Black drain hose
connector .
Drain hose
Drain hose stop
Stop
A
Using pliers, squeeze open the small green drain hose clamp and
slide onto connector between stops.
Black drain hose
connector
After hose is connected, remove towel.
If needed, see website for animated representation of this step.
Visit www.whirlpool.com/drain under FAQ tab.