Installation manual

INSTRUCTIONS TO REMOVE AND INSTALL
STEEL GRATE
U.S. PATENT NO. 4, 593, 677 &
PATENT NO. 4, 261, 327
GRATE LEG
(B) _ FIGURE 1
WITH NO CLIP _ _ SHOWS GRATE WITH ITS CLIP
-_- _ INSTALLED IN PLACE.
GRATE LE G-_-__'_ ' "_Q_-
(A) _ _dL__v
WITH SPRING CLIP _._.__
CAUTION: Care should be taken to see that all grates have been cooled before attempting to remove them.
STEP 1 - Hold grate leg (B) (the one opposite to grate leg with clip), pull horizontally away from the clip and
raise leg as shown in figure 2.
Z FIGURE 2
STEP 2 - Holding the grate leg (B) raise the grate vertically upward as shown in figure 3 until the leg (A) with
spring clip snaps out of the slot.
_/J%_</_ FIGURE 3
TO REINSTALL GRATE
Reverse step's 2 & 1. Hold grate by leg (B) and insert leg (A) with spring clip into the large slot. Bring grate to
horizontal position and pull away from the spring clip and snap locking tabs of leg (B) into the small slot.
13