Use and Care Manual

warning!
1918
Before first use, review
all warnings and caution
statements in the important
safeguards section
(pages 2-11).
ALWAYS make sure
your blender is clean and
charged before use.
Fully charge your blender
before first use. The charging
port is located under the light
indicator of the Motor Base.
(See the assembly section on
page 15 for reference.)
DON’T run your magic bullet
®
Portable Blender when empty.
DON’T microwave any magic
bullet
®
accessories.
DON’T leave your magic bullet
®
Portable Blender unattended
when in use.
DON’T charge your magic
bullet
®
Portable Blender if your
USB-C Cable is wet.
DON’T use hot or warm
ingredients in your Blending
Cup. Heated ingredients can
cause pressure to build up in
the sealed Cup that may expel
hot contents upon opening,
potentially causing personal
injury or property damage.
NEVER run the magic bullet
®
Portable Blender for more than
one minute at a time, as it can
cause permanent damage to
the motor. If the motor stops
working, pause activity and
allow the blender to cool. Your
magic bullet
®
Portable Blender
has an internal thermal breaker
that shuts the unit off when it
overheats. Letting the thermal
breaker cool down should allow
it to reset.
ALWAYS inspect your blade.
During the warranty period,
contact Customer Service
before removing the blade
for safety instructions
and replacement.
general error
Light ring will flash red.
troubleshooting:
Make sure your Cup is secured
and aligned properly. If the
blade is blocked, then try
the following:
too many blends
Light ring will flash red,
alternating between top and
bottom LEDs.
solution: Pause activity and
allow blender to cool before
next use. Don’t exceed
9 blending cycles within
6 minutes.
overheat
Light ring will turn red.
solution: Pause activity
and allow blender to cool
before next use.
errors.
• Add more liquid to the Cup
and try blending again.
• Shake blender or turn upside
down to remove blockage.
• Turn unit o and remove
blockage from blade using
a utensil.