User guide

Front Panel User Interface
INSTALLATION AND USER GUIDE 30
Initiatelocalorremote*EDIDCopyfromTransmitter:
Thiswillreplacethestored/programmedEDIDwiththelocaldisplayEDID,ortheremotedisplayEDIDifno
localdisplayisconnected.
a) MakecertainaproperdisplayisconnectedtotheVG‐TX2local‐outputconnectororVG‐RX2output
connector.
b) Press&holdbuttonF2for5
secondsuntilLEDsstartflashing,thenreleasebuttonF2.
c) LEDswillthenflash[Off‐Green‐Off]toconfirmcopyoflocaldisplayEDID,or[Green‐Off‐Off]to
confirmcopyofremotedisplayEDID,or[Red‐Red‐Red]ifnolocalnorremotedisplayisconnected(or
invalid
EDID)for5seconds.
d) LEDswillthenreturntotheirnormalbehavior,seeTable13insection5.6.
*Note:TheremotedisplayEDIDcopy(fromtransmitter)willonlyworkinpoint‐to‐pointapplications(notin
daisy‐chain).

InitiateremoteEDIDCopyfromanyReceiver:

ThiswillreplaceVG‐TX2stored/programmedEDIDwithanyofitsdownstreamVG‐RX2’soutputdisplay
EDID.
a) Press&holdbuttonF2ofthedesiredVG‐RXmodulefor5secondsuntilLEDsstartflashing,then
releaseF2.
b) LEDsontheVG‐RXmodulewillthenflash[Green
‐Off‐Off]toconfirmthecopy,or[Red‐Off‐Off]for5
secondsifanerroroccurred.
c) LEDswillthenreturntotheirnormalbehavior,seeTable13insection5.6.
VGA-TX Controls
Therearenouser‐configurableoptionsfortheVGA‐TXmodule.However,thereisan“auto‐adjust”function
whichcanbeinvokedsimplybypressingtheF2buttonontheCOREmodule.
