Setup guide

5
.
1.Specifications
Cable Required: Category 5, 5e, 6 shielded or unshielded twisted pair
Compliance: CE; FCC Class A, IC Class/class A
Video Support: VGA, SVGA, XGA, XGA-2, RGBHV, RGB, Composite, S-Video,
Component Video modes
Resolution and
Refresh Rate: Up to 2048 x 1536 at up to 72 Hz (receiver dependent)
Required Source
Impedance: Video OUT: 75 ohms;
Audio models: Audio OUT (if any): 600 ohms maximum
SPDIF audio models: 75 Ohm.
Required Destination
Impedance: Video IN: 75 ohms;
Audio models: Audio IN (if any): 600 ohms minimum
SPDIF audio models: 75 Ohm.
Audio
Characteristics: Channels: Right/Left summed;
Line Level 600 Ohm Unbalanced
SA/SAP versions are full stereo audio
Serial
Characteristics: Protocol: Asynchronous; transparent to data format;
transparent to data rates up to 19.2 kbps full duplex;
data rates to 115 kbps simplex, half-duplex modes.
SA/SAP versions are 3 wire, fixed baud rate of 9600.
Connectors: XRTx: (1) 4 position phoenix, (1) RJ-45, (2) HD15 F;
XRTx 232: (1) DB9 F , (1) RJ-45, (2) HD15 F;
XRTx SA/SAP: (1) 4 position phoenix, (1) DB9 F,
(1) RJ-45, (2) HD15 F;
Temperature
Tolerance: Operating: 32 to 104°F (0 to 40°C);
Storage: -4 to +140°F (-20 to +60°C)
Humidity
Tolerance: Up to 80% noncondensing
Enclosure: Steel
Power: +5 VDC;
Consumption: 5 watts maximum
Size: 1.2"H x 4.2"W x 4.3"D (3.1 x 10.4 x 10.9 cm)
Weight: 1.0 lb. (0.45 kg)
MTBF: 100,000 hours
CHAPTER 1: Specifications
3