Setup guide

16
MAGENTA MULTIVIEW™ SERIES
Appendix B. Setting Sync Signal
Output Termination
In some cases, it may be necessary to disable the 75-ohm termination of the video
outputs on the MultiView™ CAT5 Video System units. This can be done by opening
the case of each unit and installing jumpers on the circuit board. The settings disable/
enable the 75-ohm termination on individual units. For instance, changing a transmitter
termination affects the local monitor port only, it doesn’t affect the receivers.
Conversely, changing a receiver affects the output port of the receiver, not the
transmitter. The following diagrams show the jumper locations for the XRTx unit
75-ohm sync termination:
To enable: Both jumpers OUT (Default)
To disable: Both jumpers IN
14