User guide

Installation
MultiView™ II AK600DP/AK1200DP Installation and User Guide 12
4.5.2 Sync-mode Settings (LED1-2)
The receiver is factory-configured for auto-detecting the proper sync-mode (RepliSync-I normal/stretched). This
mode is generally compatible with all existing MultiView transmitter and receiver products that support
RepliSync (if they are also using their default settings).
However, some video sources may require a custom sync-mode setting (especially at 1080p and 1920x1200
video resolutions). For these cases, one of the other sync-modes can be selected. Note that any connected
MultiView device (transmitter or daisy-chained receiver) MIGHT also require a change to its sync-mode
settings. Otherwise, you may not get a proper video display output at one or more receivers.
Perform the following procedure while the receiver is in the normal operating state (CFG indicator is off):
1. Press and hold the CFG button until the CFG indictor is ON. Release the CFG button.
a. LEDs 1-8 will show the current value for all Mode-1 configuration settings as bright (same as
ON), dim (same as OFF).
2. Press and release the SKEW/SEL button once.
3. LED indicators 1 and 2 should be illuminated (either ON or DIM); all others (indicators 3-8) should be off.
4. Press the UP and DOWN buttons to step through the available sync-mode settings as shown below.
5. To leave configuration-mode, leave the buttons untouched for 10 seconds or press the CFG button.
Table 3: Sync-Mode Settings
LED1
LED2
Front Panel View
Sync-mode Setting
dim
dim
The receiver will auto-detect the required RepliSync-I
mode (“normal” or “stretched”). This is the factory-
default setting.
dim
ON
Force RepliSync-II mode. This is compatible with MultiView
II “RepliSync-II” mode only (when connected to a MultiView-
II transmitter).
ON
dim
Force fixed-sync mode. NOTE: The source MultiView
transmitter must also be in fixed-sync mode. Note that H/V
polarity settings must also be selected at each receiver.