User guide

Installation
MultiView™ II AK600DP/AK1200DP Installation and User Guide 6
Chapter 4 Installation
This section describes the following installation topics:
 Data mode configuration
 Prerequisites to installation
 Installation procedure
 Post-installation adjustments
 Post-installation configuration settings
This equipment is not intended for, nor does it support, distribution through an Ethernet network.
Do not connect these devices to any sort of networking or telecommunications equipment!
Do not connect DC power until instructed to do so.
4.1 Option-Module Configuration
If your MVII-AK600(1200)DP receiver is equipped with one of these option modules: (232), (SA) or (SAP), then
the following information will be important to review BEFORE installing the receiver:
The MVII-AK600(1200)DP-232 serial receivers are factory-configured for duplex-serial with full modem
controls. The mode must be changed to simplex if you are using one of the following installations:
 Daisy chained receivers.
 Using a multi-output transmitter (T4).
 Using a MultiView distribution amp (MV-9D).
 Using a MultiView matrix switch (Mondo-III or MV-16x16).
Please refer to Appendix-A for (232) module configuration information.
The MVII-AK600(1200)DP-SA version offers RS232 duplex serial in addition to stereo audio. The serial
interface is 3-wire (TX, RX, GND) and does not support full modem signals. The maximum serial baud rate is
9600. Simplex modes are supported without jumper or other changes by simply using the TX signal only. SA-
equipped receivers require no other special configuration.
The MVII-AK600(1200)DP-SAP version offers pollable RS232 duplex serial in addition to stereo audio. The
serial interface is 3-wire (TX, RX, GND) and does not support full modem signals. The factory-default serial
baud rate is 9600 baud, but this is a user-configurable option using “SAP-II” serial commands. Simplex modes
are supported without jumper or other changes by simply using the TX signal only. The SAP-module capability
of polling and interacting with specific receivers requires that each receiver have a unique address setting.
Please refer to Appendix-C for (SAP) module configuration information.