Setup guide

.
21 19
APPENDIX E: Skew Compensation Module
Appendix E. Skew Module
The AK600 receivers have an optional skew compensation module that can
be installed or removed.
To install the skew compensation module:
1 Remove top cover.
2 Remove the 3 jumpers from J16 pins 1-2, 4-5, 7-8.
4 Insert the Skew assembly onto the PCB using 11 pin headers J16 and J17.
5 The correct orientation of the skew board is to place the side with the Magenta
logo into header J17.
6 Reassemble unit.
Removal is the opposite of the above. Ensure 3 jumpers are installed in
locations shown in Figure E-1.
Figure E-1.
Install 3 jumpers on J16 in
positions 1-2, 4-5, 7-8 as
shown if skew board is
removed
.
Skew module placement on
headers J16/J17.
J17