User guide

Installation
MultiView™ II DVI-Tx Installation and User Guide 11
5.4 Adjustments
This section describes how to make the following adjustments:
 Cable distance (EQ) compensation
 Skew compensation
Note that the factory-default behavior of the MVII-DVI-Rx-1K “auto-adjust mode enabled” for the EQ and skew-
comp. To exit auto-adjust mode, simply attempt to make a manual adjustment to either EQ or Skew.
To re-enable auto-adjust mode, simply push both UP and DOWN buttons simultaneously when the
receiver is operating in “normal mode”.
5.5 Cable Distance (EQ) Compensation Settings
When the MVII-DVI-Rx-1K is operating in normal mode (CFG indicator is off), it is possible to quickly adjust the
EQ. The EQ/SKEW indicators 1-8 will change accordingly to show (in “bar-graph” form) 0 to 100% of the
available EQ adjustment range.
For best results, use the Magenta EQ/Skew test pattern image if possible. A test pattern
image and video instructions is available at http://www.magenta-research.com/test.
The following figure shows the test image you can use to make the EQ adjustment.
Figure 5: EQ-adjustment test image
To adjust EQ:
1. From normal-mode, press and hold the UP or DOWN button until the SKEW/RGB indicator turns on
(VIOLET). Release the UP or DOWN button.
2. Press the UP or DOWN buttons repeatedly to adjust the EQ setting, either one step at a time or hold
for auto-repeat.
3. To exit EQ-ADJUST mode, leave the buttons untouched for 10 seconds, or press the CFG button
once.