User guide

Option Module Settings: DVI-TX-232
MultiView™ II DVI-TX Installation and User Guide 23
Appendix B Option Module Settings: DVI-TX-232
The (232) option module has internal jumper settings that can be configured for various serial modes and CAT5
cable lengths.
To access the (232) module board:
 Make sure the unit is powered OFF.
 If necessary, unplug all cables to the unit.
 Unscrew the top cover screws.
 Unscrew the DB9-F hex-standoffs.
 Lift the cover off.
 Carefully unplug the (232) module from the main board.
Transmitter (232) module jumper settings
Mode Type
Baud
(Max)
JP1
1-2
JP1
3-4
1
Simplex
(one way)
(to 1500 ft)
115k OUT IN
2
Full Duplex
(2 way)
Short (< 500 ft)
19.2K OUT OUT
3/5
Default
Setting
Full Duplex
(2 way) Long
(to 1500 ft)
19.2k IN OUT
4
Half Duplex
(2 way) Long
(to 1500 ft)
115k IN IN
NOTES:
 Mode 1 is required when using multi output transmitters
and when daisy chaining receivers.
 Mode 3 may introduce noise in video over 1,000 ft when
serial communication occurs. This does not apply if Mode 5
is used on the receiver.
 JP1 5-6 & 7-8 terminate the serial bus and must be IN on
the transmitter.
Example of
jumper-plugs
JP1 Pins
(side view)
3
1
2
4
6 5
8 7