Owner's Manual

References
Get Started at Home
Power On
Press the Power button on the right side
of the device to turn the device on.
Connect to Wi-Fi
1. Tap
> > from the
Home screen.
2. Slide On/Off button to
.
3. Tap
again to see networks.
4. Enter password (if applicable).
5. Tap
.
Get Started in Your Vehicle
1. Get a clear view of the sky.
2. Clean the area on the windshield
where you want to mount the device.
Allow the surface to dry.
3. Hold the suction cup firmly against the
windshield surface
4. Push the lever down towards the base.
5. Screw the baseplate on the cradle.
6. Attach the device onto the mount.
Tip: Refer to FAQs and
Troubleshooting for information about
alternate mounting solutions.
Connect to Wi-Fi Hot Spot
1. Tap
> > .
2. Slide the On/Off button to
.
3. Tap
again to see networks.
4. Enter password (if applicable).
5. Tap
.
Note: Wi-Fi must be
to sync your
TRX7 with your myTRXjournal account.
Get Started.
Important
Various factors influence GPS signal
reception. To improve the signal reception
and time to calculate the current location:
• Leave any enclosed structure (garage,
parking structures, etc.).
• Make sure you have a ‘clear view of the
sky’. Buildings and trees can have an
impact on GPS signal reception.
• Make sure that the device is mounted
where it can have a clear line of sight to
the windshield.
Note: The first time the device calculates its
location can take up to 1 minute. Subsequent
times will be 15 seconds on average.