Installation manual

Programming Page 15
Programming for Esprit and Stand Alone
To enter programming mode with Esprit or in Stand Alone mode:
1. Connect an Esprit 636 or 646 to the “Program” connector.
2. Press the “Esprit Mode Programming” button.
3. Press [
ENTER] on your Esprit keypad and enter the installer code
(default: 757575).
4. Enter the desired section number.
Esprit Programming
Section Feature Details
[000] Installer code Set installer code (4 or 6 digits, default:
757575)
[004] PGM initial state
Option [6] PGM1 initial
state
Off = Normally open (default)
On = Normally closed
Option [7] PGM2 initial
state
Off = Normally open (default)
On = Normally closed
[301] to
[332]
User code assignment [301] = User 01
[332] = User 32
Assign a valid user code from the Esprit
Panel into the RTX3. To delete a user
code, press [
2ND] and then [ENTER].
[201] to
[232]
Remote control
assignment
[201] = Remote control 01
[232] = Remote control 32
Press [
ENTER]. After the confirmation beep,
press and hold any button on the remote
until you hear two beeps.
To delete a remote control, press [
2ND]
followed by [
ENTER].