Specifications

60
Equip tab
Instrument: Allows you to set the equipment type that you will
be using (ProMark3 Base or ProMark3 Rover).
If Instrument=ProMark3 Rover, the three buttons that follow
are the following:
Rover Settings: Used to set the rover receiver to the correct
parameters and to instruct the receiver that it is a rover.
DGPS Configuration: Runs the DGPS Configuration utility
through which UHF, Beacon, NTRIP or Direct IP configu
-
rations can be implemented.
RTK Initialization: Gives access to the list of initialization
methods through which the rover can be initialized.
If Instrument=ProMark3 Base, the button that follows is:
Configure Base: Sets up the base antenna, records the
correct antenna height and the antenna type, and sets the
raw data recording function.
The rest of the buttons on this tab is independent of the se-
lected instrument:
Localization: Allows you to align on a local coordinate system.
Monitor/Skyplot: Allows you to view GPS constellation, posi-
tion result and data quality.
Tolerances: Allows you to set operating tolerances.
Comm Setup: Not used (all parameters dimmed).
Peripherals: Allows you to acivate and set peripherals (laser,
depth sounder, light bar).
About FAST Survey: Allows you to view information about
FAST Survey and change your registration.
Rover Equip Tab
Base Equip Tab