Specifications

Setting Up the Rover

Install the unit on its range pole:

1. Mount the GNSS antenna on top of

the pole. For a “Bar” initialization,

use a quick release extension so you

can easily move the antenna between

the kinematic bar and the range

pole. For the other initialization

methods, there is no such require

ment.

2. Mount the radio modem onto its

bracket using the screws, nuts and

washers provided.

3. Secure the radio bracket onto the

pole.

4. Connect the GNSS antenna to the

ProMark3 RTK using the cable pro-

vided.

5. Connect the radio cable to the back

of the ProMark3 RTK.

6. Attach the field bracket onto the pole

7. Place the ProMark3 RTK into the field bracket

8. Measure or read the height of the GNSS antenna:

• Slant measurement: Use the measurement tape pro-

vided. Insert the end of the tape into one of the three

or four hooks located on the circumference of the

GNSS antenna radome. Unroll the tape toward the

ground. Position the tip of the tape measurement onto

the ground. Block the tape and read the value indi

cated at the base of the tape: this is the slant height.

• Vertical measurement: Use a conventional tape to

measure the vertical distance from the base of the

GNSS antenna to the ground. If you are using a gradu-

ated range pole, read the value given by the gradua-

tion.

2-3

6-7

H Slant

H Vertical