Specifications

250
LCD test: Consists of displaying different colors and shapes
with different levels of brightness and contrast. There is no
user action required. This test can be skipped by pressing the
ESC key.
Stylus test: Follows automatically. Takes place as described
in
Calibrating the Screen on page 29. You can skip that test
by pressing the ESC key.
Speaker test: Tap Passed after the speaker has correctly emit-
ted three different sounds with increasing volume. The test
will be repeated indiefinitely until you tap Passed (or Failed if
the test failed).
Serial Port test: You first need to connect a female plug on the
ProMark3 I/O module’s RS232 port on which pins 2 and 3
have been shorted. Then tap OK to start the test.
SD card test: You first need to insert an SD card in the unit
and then tap OK.
At the end of the tests, the initial dialog box reappears on
which you can see the tests that passed and those that failed.
Note that Bluetooth is tested through an internal routine (see
BT ADDR:... line).
Tap OK to close the Tests dialog box.