Specifications

249
16.Diagnostics & Upgrade Tools
This chapter focuses on the different ProMark3-embedded
tools that allow you to test the operation of your ProMark3.
Testing ProMark3’s Internal Peripherals
Use the Tests utility.
This utility can be found in the Utilities folder. To run this util-
ity from the ProMark3 workspace screen, double-tap the Utili-
ties icon and then the Tests icon.
The Tests utility allows you to test various elements in the unit,
namely USB, keypad, LCD, touch screen, speaker, serial port,
Bluetooth and SD card.
After launching Tests, tap Start. All the tests are then run in
succession. You can skip the test in progress by tapping Skip,
or all the remaining tests by tapping Skip All.
USB test: Plug a Mass Storage USB device, wait about 10
seconds and then tap OK.
If the test is successful, the unit will switch to the next test.
If the test fails, a Failed button will appear at the bottom of the
screen, next to the OK button. You can either retry the test by
tapping OK, or acknowledge that the test failed by tapping the
Failed button. The unit will then continue with the tests.
Keypad test: Successively press the key corresponding to the
white spot shown on the screen. If the key is pressed success
-
fully, the spot turns green and a new white spot appears on an-
other location on the screen prompting you to press the
corresponding key, etc. Tap OK at the end of the test.