Specifications

220
- Tap OK to close the DGPS Configuration window. The fol-
lowing two messages are displayed successively: “Please
wait...” and “Processing incoming data packets...”.
- Tap OK to close the message window.
- Start your job using the chosen software application.
Returning to Autonomous GPS Mode
- On the ProMark3 workspace screen, double-tap the DGPS
Configuration icon.
- Tap on the Select Mode button.
- In the Select Differential Mode window, enable the None
option.
- Tap OK to close the window. This takes you back to the
DGPS Configuration window where you can read the
choice you have just made.
- Tap OK again. The window is closed and ProMark3 starts
operating instantly in Autonomous GPS mode.
How to End a Direct IP or NTRIP Session
You don’t need to cut off the GPRS connection and the NTRIP
or Direct IP connection before shutting down the unit.
Actually, turning off the ProMark3 RTK and cell phone while
a NTRIP or Direct IP session is active is not a hazardous op-
eration.
When you next turn on the two units, the re-start procedure
will take place according to the instructions in the next sec-
tion (Subsequent Uses).
However, after you cut off the connection, you may have to
wait up to 10 seconds before a new connection is possible,
due to time-outs in servers.
Subsequent Uses
Next time you turn on ProMark3 RTK and you run the DGPS
Configuration utility, you will be prompted to run the same
DGPS mode as the one you last used. If it was Direct IP or
NTRIP, the configuration you last used is preset. If it was Mo
-
bileMapper Beacon, the last station used is preset.