Specifications

213
- Tap OK again after the message “Beacon Tuned Success-
fully!” appears. This takes you back to the previous screen.
- Tap Details to read the current settings and performance
indicators of the MobileMapper Beacon. The current tun
-
ing settings include reception frequency, MSK rate and
station ID of the reference station being received. The per-
formance indicators are the lock status (No/Yes), the sig-
nal strength, measured in dBµV, and the Signal-to-Noise
Ratio (SNR) in dB. See screen example opposite. Refer to
page 266 for more detail.
- Tap OK to close this window and return to the previous
screen (Settings screen).
- Tap OK for all the settings to take effect. The DGPS Con-
figuration screen is now displayed.
- Tap Connect to allow MobileMapper Beacon to send its
correction data. When connection is effective and correc
-
tions are being sent, the Connect button is changed into a
Disconnect button and the status bar at the bottom of the
screen indicates the amount of incoming data packets
since you tapped the Connect button.
The top of the
screen gives general status information on the DGPS mode
currently selected.
NOTE: If you had to use the now inactive Select Mode and
Settings buttons, you should have first to re-activate them
by tapping on the Disconnect button. This would discon-
nect the source of DGPS data from ProMark3 and so
would stop the flow of incoming data packets.
- Tap OK to close the DGPS Configuration window. The fol-
lowing two messages are displayed successively: “Please
wait...” and “Processing incoming data packets...”.
- Tap OK to close the message window.
- Start your job using the chosen software application.