Specifications

186
If you want to upload only a region of the background map:
- Click
- Drag a rectangle around the desired region and then
release the mouse button.
The limits of the region are now represented with a rectan-
gle. You can still resize or reshape the rectangle by drag-
ging its control points (corner and mid-side points). You
can also move the whole rectangle by dragging the mouse
cursor from inside the rectangle.
- When the location and size of the region is okay, click out-
side of this region.The region is now defined and its limits
are represented by a thick green line.
NOTE: To delete the region and start over, resume the
above three steps.
Start the upload procedure as such by selecting File>Upload to
GPS>Background Map. MobileMapper Office tests the connec-
tion to the ProMark3 (the software needs to know which type
of receiver the map is intended for). Once the data link is es-
tablished, you can make one of the following three choices:
• Upload to GPS Unit if you want to upload the map
directly to the ProMark3.
• Upload to SD Card Reader if you simply want to copy
the background map to the SD card inserted in the
local SD Card Reader (you will use that SD card later
in a ProMark3).
•Or Store on Hard Drive if you just want to create now
the IMI file on your hard disk so that later you can
copy it to an SD card using the local SD card reader.
1. If you select Upload to GPS Unit, then:
• Click Next >
• After the GPS unit has been detected on the USB or
RS232 port, click Next > again.
• MobileMapper Office indicates the size of the map
file and the remaining memory space on ProMark3.
Click
Finish.