Specifications

142
Using ProMark3 as a Reference Station
- Mount ProMark3 on a tripod placed over a control point,
turn it on and then double-tap the Mobile Mapping icon.
- Press the MENU key, tap successively Setup and Storage to
choose the media (SD Card or Internal Memory; SD Card
recommended) where to store the reference station data
ProMark3 is going to collect.
- Press the LOG key and then tap Reference Station. The Site
ID screen is now displayed.
- Enter a Site ID (there is a four-character limit) as you
would enter a job name, and then press ENTER.
From now on, ProMark3 will operate as a reference station
until you quit the Mobile Mapping function. It is therefore
important that you not move the receiver or any optional
external antenna until you quit the function.
Before leaving the reference station, press the NAV key
until you can see the Satellite Status screen. Check that
the letter “R” now appears in the upper-right. This means
the receiver is recording reference station data and you
can now proceed with your job.
- After your job is complete, come back to the ProMark3
reference station, press the MENU key and tap Exit. The
ProMark3 exits from the Mobile Mapping function.
- Turn off the unit.
Quitting the Mobile Mapping Function
Press the MENU key and tap Exit. This takes you back to the
ProMark3 workspace screen.