Specifications

128
If you wish to change the logging interval while you are
logging a line feature, you first need to pause the logging
of the feature:
- Tap Options and then Pause <line feature name>
- Tap Options again and then Logging Interval. Set the
new logging interval as explained above.
- After changing the logging interval, tap Options and
then Resume <line feature name>. The receiver will con-
tinue to log the feature, but this time according to the
new logging interval.
4. Logging and Describing an Area Feature
Basically, you use the same procedure as when you log a
line feature, especially regarding the need for defining a
logging interval (see 3. above). The only difference
between a line and area feature is that for an area feature,
the first and last position calculated by the receiver are
connected when you close the feature.
Record the attributes of an area feature as you do for a
line feature (see page 126):
- Tap the name of the area feature from the list of fea-
tures and tap the Log button. ProMark3 starts logging
the area feature.
- Choose a logging interval (see explanations given for a
line area on page 127). This takes you back to the
Logging screen where the list of attributes for the fea-
ture is displayed
- Describe each attribute by selecting or entering the
appropriate attribute value for each of them.
This screen displays the
current values of perime-
ter and area measured
since you started logging
the feature (+ number of
satellites and PDOP)
Logging screen