Specifications

120
2. Re-initializing on an intermediate control point
If the “Loss of Lock. Reinitialize” message arises when you
are performing a Stop & Go survey:
• Acknowledge the alarm by tapping anywhere outside of
the message window.
• Walk to the control point you last surveyed.
• Check that you have enough satellites and a good PDOP
on that point
• Press the LOG key.
• Select “Known” in the Initialize field, then tap the Site ID
corresponding to this point (remember in our example you
named that point“CP10”).
• Tap Log and wait for the Remain field to countdown to zero.
• Walk to the point where the alarm message occurred keep-
ing the pole range always vertical and making sure the
antenna has continuously an open view of the sky.
• When you have arrived at the point, press the LOG button,
rename the Site ID and continue with your survey.
If the “Loss of Lock. Reinitialize” message arises when you
are performing a Kinematic survey:
• Acknowledge the alarm by tapping anywhere outside of
the message window.
• Tap Done to close the observation file.
• Walk to the control point you last surveyed.
• Check that you have enough satellites and a good PDOP
on that point
• Press the LOG key.