Specifications

Uploading Control Points to ProMark3

You can uploads control points from an open GNSS Solutions

project to your ProMark3. Reference and target points CAN-

NOT be uploaded.

To know the definition of each of these point types, please

read the “Point Properties” section in the GNSS Solutions

Reference Manual (in Chapter 5).

During this operation, GNSS Solutions will transform fixed

control points into control points (for stop & go or kinematic

initialization) and non-fixed control points into waypoints.

Fixed control points can only be uploaded to the ProMark3’s

internal memory, not on the SD card. So make sure the inter-

nal memory is used as storage medium on the ProMark3 when

uploading your control points (press MENU, tap Setup, Stor

age, Internal Memory and then OK).

NOTE: You can also keep “SD Card” as the storage medium

and temporarily remove the SD card from the unit before

running the upload function. In this configuration, i.e. in the

absence of the SD card, the upload function will in fact load

the control points into the internal memory. After you re-in

sert the SD card into the unit and you start a survey, data will

be saved to the SD card, as requested by the Storage setting.

Fixed control points will also be available as waypoints in the

ProMark3. On the map screen, these will appear as small yel-

low triangles whereas “normal” waypoints will continue to ap-

pear using the usual representation (a yellow cross square).

See opposite.

Control points can only be

uploaded to the ProMark3’s

internal memory!

Ctrl

Wpt