Specifications

English

8. When you see a message saying, “Operating system updated

successfully,” tap OK on the OS Loader window.

9. Tap in the upper right of the Windows screen to exit

back to the desktop.

10.Turn off the receiver by tapping , then Shut Down and

then the OK button.

11.After a few seconds, MobileMapper CX’s green LED will

shut off. You may then press the power button to turn the

receiver back on.

12.You may verify that the new OS firmware has been suc-

cessfully uploaded by tapping:

>Settings>Control Panel

13.Scroll down to the Magellan System Info icon. Double-tap

on this icon. Confirm that the OS F/W Version is that which

you just uploaded.

Updating MobileMapper CX GPS Firmware

1. Go to ftp.magellangps.com and copy the GPS firmware zip

file (beginning with an “E” such as “E032.zip”) from the

/Mobile Mapping/MM CX/Firmware/GPS/ folder to any

folder on your PC.

2. Open the GPS firmware zip file and extract the two com-

pressed files to the same directory on your PC.

3. Copy the extracted files to MobileMapper CX’s SD card by

using either a card reader or ActiveSync

. To use Active-

Sync, turn on MobileMapper CX and connect it to your PC

using the USB cable that runs between MobileMapper

CX’s I/O module and your PC’s USB port. This causes

ActiveSync to launch on your PC and connect to

MobileMapper CX as a “Mobile Device.” Do NOT set up a

partnership when connecting to the PC with ActiveSync.

1. Make sure the USB device switcher has been set to operate in

“USB Serial for ActiveSync”. See

page 5.