Specifications

English

- Tap OK to close the DGPS Configuration window. The fol-

lowing two messages are displayed successively: “Please

wait...” and “Processing incoming data packets...”.

- Tap OK to close the message window.

- Run GPS Status (see Viewing Current GPS Status on

page 14) and check that MobileMapper CE is now operat-

ing in DGPS mode.

- Start your application.

Returning to Autonomous GPS Mode

- Tap on , then Programs>GPS Utilities>DGPS Configuration.

- Tap on the Select Mode button.

- In the Select Differential Mode window, enable the None

option.

- Tap OK to close the window. This takes you back to the

DGPS Configuration window where you can read the

choice you have just made.

- Tap OK again. The window is closed and MobileMapper CE

starts operating instantly in Autonomous GPS mode.

Subsequent Uses

Next time you turn on MobileMapper CE and you run the

DGPS Configuration utility, you will be prompted to run the

same DGPS mode as the one you last used. If it was Direct IP

or NTRIP, the configuration you last used is preset. If it was

MobileMapper Beacon, the last used station is preset.

This means the only thing you will have to do to get the Mo-

bileMapper CE running, and provided you agree with all the

default choices, is to tap on the Connect button and then start

using the corrections received by tapping OK.

CAUTION! For Direct IP or NTRIP, you will have to re-establish

the GPRS connection via Bluetooth (see Subsequent Uses on

page 26) before running the DGPS Configuration utility. For

MobileMapper Beacon via Bluetooth, you will have to re-es-

tablish the Bluetooth link before running the DGPS configura-

tion utility.