Specifications

English
35
To create a second Direct IP configuration, you would tap
the down arrow to the right of the Direct IP Configuration
field and select New. The Add button would appear again
under the field. You would then tap this button, enter the
three parameters of the second configuration and tap OK
to save this new configuration.
- After selecting the desired configuration from the Direct IP
Configuration field, set the Real-Time Correction Age Limit
parameter according to your needs (see recommendations
on page 63).
- Tap OK. This takes you back to the DGPS Configuration
window. On top of the screen, you can read part of the set-
tings you have just made.
- Tap the Connect button. The DGPS Configuration screen
now indicates the amount of incoming data packets (bot-
tom of the screen) as well as the status of the DGPS mode
(top of the screen).
- Tap OK to close the DGPS Configuration window. The fol-
lowing two messages are displayed successively: “Please
wait...” and “Processing incoming data packets...”.
- Tap OK to close the message window.
- Run GPS Status (see Viewing Current GPS Status on
page 14) and check that MobileMapper CE is now operat-
ing in DGPS mode.
- Start your application.