Specifications

English
34
Direct IP
Warning! Using Direct IP requires that you have previously fol-
lowed the entire procedure described in Step-by-Step Proce-
dure for Establishing a GPRS Connection Via Bluetooth on
page 17.
Then do the following to implement the Direct IP DGPS mode:
- Tap on , then Programs>GPS Utilities>DGPS Configuration.
- Tap on the Select Mode button.
- In the Select Differential Mode window, enable the Direct
IP option.
- Tap OK. The Direct IP Settings window opens in which you
can store several Direct IP configurations and also set the
Real-Time Correction Age Limit parameter.
Each Direct IP configuration holds the key information
allowing MobileMapper CE to connect to a given correc-
tions provider. Having the capability to save several Direct
IP configurations in MobileMapper CE will therefore allow
you to quickly change the corrections provider without
having to re-enter the relevant connection parameters
each time you do that.
- To enter your first Direct IP configuration, with New
selected in the Direct IP Configuration field, tap on the Add
button and then enter the following parameters:
• Name: Direct IP Configuration Name (freely choose a
name)
• Host: IP address
• Port: Port number
(The last two parameters should have been passed on
to you by the correction provider.)
- Tap OK. The name of the configuration you have just cre-
ated is now pre-selected in the Direct IP Configuration field.
Two new buttons (Edit and Delete) are shown under this
field allowing you to respectively edit or delete this config-
uration. When you edit an existing configuration, note that
you cannot change its name.