User Guide

Selecting POIs from Marked Regions:
– After selecting (marking) a region, you can select whether or not to
upload the POI’s.
– Along with the check box for marking the region is the other box used to
select POI’s.
– Clicking on the “P” will turn the selection on or off. A greyed “P” indicates
that option is turned off and will not be uploaded.
Uploading Regions to a GPS Receiver:
–To upload regions from the Saved Regions List to your GPS receiver, you
need to make sure your PC has been properly connected to the GPS
receiver and the required communication options have been set.
– Make sure the regions you want to be uploaded have been marked in the
Saved Regions List and that the total amount of memory used will fit into
the memory restrictions of your receiver.
– From the Regions menu, choose Upload to GPS...
– Follow the instructions in the dialog information box.
– If the estimated total size of the regions you have marked is greater than
available memory on the receiver, a corresponding warning appears. If
so, then try to lessen the size of marked regions by editing the region
rectangles and referring to the table’s status box.
– Estimated size of regions may differ from the final one, so the corre-
sponding warning can appear after the regions have been converted. In
this case, reduce the region size and try again.
– When uploading regions, all current regions stored in your receiver will
be deleted.
– Refer to the User Manual on downloading waypoints, tracks and routes
from the GPS receiver to your PC.
– Be sure to note that the upload or download process may take a certain
amount of time in order to complete the file transfer.