Owner's Manual

The icons below the addresses indicate if new firmware or maps are available for
your receiver after you have checked for updates. If the icons are active, you can
select them to install the updates.
6. Select the Sync icon
to begin syncing all the addresses currently in your receiver
to the Content Manager.
7. The addresses contained in your receiver are now listed in the Address Book for the
Content Manager.
Adding an Address (Do not use periods in the address. Addresses with periods, i.e., “St.”, will
not validate properly.)
1. You can add an address to the Address Book using Content Manager.
2. Select the Add Address icon
.
3. Fill out the information for the address in the Address information box and select Save.
4. The new address is created. Note the icons following the name. The Validate icon
indicates that this is a new address and the needs to be validated before syncing to the
receiver.
5. Select the Validation icon
to validate this address. When the validation is
sucessful, the validate icon is removed from the address.
6. The checkmark
following the address indicates that this address needs to be
synced to the receiver.
7. Select the Sync icon
to sync the changes to your receiver.