Instructions

S Section 3

Installation

Fig. 7

Ground (–) lead

(black)

Positive (+) lead

(red)

Ignition-Switched Fuses

Charging Cradle Cord

Radio

Heater

Accessory

Note: For maximum protection of charging cradle and

vehicle, it is recommended that a 10 AMP

Slow Blow fuse is installed in the Positive (+) lead (red).

Charging Cradle

Direct Wire–Vehicle Installation 12–14 Volt Only (Not for 24-Volt Systems)

A 6’ power accessory cord is available to facilitate the direct-wiring of the rechargeable system (Fig. 7). MAG Instrument recommends

using an ignition-switched circuit (fused for 10 or 15 AMPS). This is most often the radio or accessory fuse. The Positive (+) lead (red) is

connected to the fuse output, and the Ground (-) lead (black) wire should be attached to a metal part of the chassis, which serves as a

battery ground return.

10 AMP

(See Note)

A Typical Installation

1. Locate and mount the cradle using appropriate screws and anchors for

the location and material.

2. Attach end of DC power cord or AC converter to charging cradle by

inserting round plug into power connection port in the side of the

charging cradle (Fig. 6, 7 & 10).

몇

NOTICE: Never pull on the power cord when unplugging the AC adapter.

Grasp the plug directly.

CAUTION: Make sure cable cannot be pinched. If cable is pinched it can

cause immediate short and wires can get hot, melt plastic, and create a

fire hazard.

Fig. 6

Power connection port