Instructions

Section 1

The Flashlight

1. Face Cap - The removable face cap, which is threaded onto the

head, is O-ring sealed and retains the polycarbonate lens and the

precision-engineered reflector that is the heart of the optical system.

2. Head - The head houses the reflector and

the LED module. The flashlight’s Quick-Adjustable

Beam operates by rotating the head. About ¼ turn

of the head causes the beam to vary between a

wide floodlight setting and a narrow spotlight

setting (Fig. 1). To remove the head, first remove

the face cap and reflector; the head is then free to

slide down the barrel. This maneuver provides

access to the O-ring seal that is seated in a groove

on the outside of the barrel, near the head end,

and seals the head-barrel assembly against grit

and moisture.

3. Switch - Sealed, flush-with-the-barrel electronic switch provides

access to five different functions – Full Power, Low Power, Strobe

(12x/sec), Eco, and Momentary On/Off.

4. Serial Number - Your flashlight’s unique serial number is

permanently engraved on the barrel for ease of identification and

registration. Please note your serial number for future

reference:____________________.

5. Tail Cap - The tail cap is threaded onto the barrel and retains the

Lithium Iron Phosphate (LiFePO

) rechargeable battery. The tail cap/barrel

junction is sealed by a lip seal that prevents entry of moisture and grit,

while allowing the venting of any gas that may be generated within the

flashlight. The tail cap can be removed to inspect/replace the battery and

to maintain/replace the lip seal.

Fig. 1