Specifications

5.1.3 15-Pin D-Sub Female connector (RS232/Audio)
This connector provides serial link and audio link to the modem.
Pin Number
Name EIA designation Type Note
1
DCD Data Carrier Detect Output
2
TX Transmit Data Input
3
BOOT Input
4
MICROPHONE + Input With 2VDC bias output
5
MICROPHONE - Input With 2VDC bias output
6
RX Receive Data Output
7
DSR Data Set Ready Output
8
DTR Data Terminal Ready Input
9
GND Ground Ground
10
SPEAKER + Output
11
CTS Clear To Send Output
12
RTS Request To Send Input
13
RI Ring Indicator Output
14
RESET Input Pull low for 100ms to reset,
module requires 5-7s to reboot
15
SPEAKER - Output
Specification of microphone and speaker to be connected:
Parameters Min Typical Max
Microphone current @2V/2K Ohm 0.5mA
Microphone input level 100mVpp
Speaker output current 150 Ohm/1nF 16mA
Speaker impedance 32Ω 50Ω
Please refer to the document "Application note - Power supply & Audio" for more information about audio connection.
CAUTION
If the CTS and the DTR signals are shorted together, the modem will enter a factory download mode. In this mode,
the modem does not behave in a normal manner and can not connect to the cellular network.
It is recommended that CTS and DTR pins should never be short-circuited. If the application requires to use "flow-
control spoofing" cables, make sure that they do not connect CTS to DTR.
20 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
[e-mail]