Specifications

Note: If the Maestro 100 2G is connected with another DCE device please use a cross cable.
3.5 Connecting the DC power supply
If delivered with the power cord accessory, on page 22, use the open ending of the power cord to connect a DC
supply. Refer to the following for power supply requirement:
– Input voltage range : 5-32V
– Rated current: 650mA
Figure 3.5.1: Power cord not included in the package
Plug the DC Molex connector of the power cord in the modem and it will turn on automatically. The status indicator
led will light when power is applied. After few seconds it will blink slowly, meaning the modem is registered on the
network.
Figure 3.5.2: Side view showing power and serial connector
14 Confidential, the whole document is the sole property of Maestro Wireless Solutions ltd.
[e-mail]