User manual

MADRIX PLEXUS User Manual (English) 115

'Slave with Speed'

will become available when Slave is selected above. Activate/

check this entry and the interface will synchronize with the

'Master' and also accept any Speed changes from the Master. If

the function is disabled/unchecked, the device can function with

its own Speed settings.

'Slave with Freeze'

will become available when Slave is selected above. Activate/

check this entry and the interface will synchronize with the

'Master' and also accept any Freeze options from the Master. If

the function is disabled/unchecked, the device can function with

its own Freeze settings.

More Information

You don't need to configure Timers for your Slave devices, when the Master-/Slave-

Synchronization should be used. Only the Master interface needs to have Timers configured (if

you wish to use Timers). The Master will automatically communicate the Timer(s) to the Slave

device(s). You can configure Timers in the PLEXUS Configuration dialog.

When using Master-/Slave-Synchronization that means you are going to use more than 1

PLEXUS interface. Please make sure to record (Step 4) Recording) and convert effects (Step 5)

Converting Files) that are set up correctly for all of your devices (regarding size of your Patch/

virtual matrix and DMX Universe output, for example).

Intensity Group is a feature that can be used in combination with Remote Control.

When setting up the Sync mode, it is important to pay attention to the Group settings as well.

Please continue with the next chapter Group.