Owner`s manual

4 PREVIOUS, NEXT, STOP, PAUSE

prev ( ): Pressing this button momentarily will return you to the begin-

ning of the current DVD chapter (or CD track). Pressing it repeatedly will

move you backward through the available chapters/tracks, one at a time.

Note that some DVD discs may prevent you from using this button (and

others) at certain times.

next ( ): Pressing the next button momentarily will advance the PMDT

to the beginning of the next track on a CD or the next chapter of a DVD.

Pressing it repeatedly or camping on, it will move forward through the

available tracks/chapters, one at a time. Note that some DVD discs may

prevent you from using this button (and others) at certain times.

stop: Unfortunately, DVD players and CD players often treat the stop but-

ton differently. This can be confusing. We allow you to make the PMDT

work the way you think it should (see the section on Disc behavior, on

page 38). However, by default,

• Pressing stop once with a CD will actually stop the disc from

spinning (introducing a slight delay upon pressing play, as

the disc spins up).

• Pressing stop once with a DVD will actually pause the disc

with a blank screen, allowing you to resume where you left

off in a movie quickly and easily by pressing play.

pause: Pressing this button during play will pause the PMDT at that

point within the track; the time display will blink slowly as a reminder

that you are in the pause mode.

5 NAVIGATION CLUSTER

This centrally located cluster of four buttons (up, down, left, right) dupli-

cates the same set of buttons on the PMDT’s front panel, allowing you to

operate the PMDT fully from the remote control.

up/down/left/right: Use the up, down, left and right buttons to navigate

menus (both the PMDT’s own menus and those of the DVD discs you

play). In addition, during normal play (as opposed to when you are in a

menu), left and right can be used to access scan reverse and scan for-

ward

, respectively.

return: Use the return button while playing either a DVD or CD to return

you to where you were on the disc after a stop command. (It is possible

that the authoring of a DVD will explicitly prohibit doing so, in which

case nothing will happen.) The return button may also be used by a

DVD disc author as part of the on-screen menu system navigation.

menu: In the DVD standard, there are provisions for both disc menus

and player menus, which can get confusing. When you first press the

menu button, you will be presented with a choice on the on-screen

display: