Owner`s manual

13
Y/G Pb/B Pr/R Csync Y/G Pb/B Pr/R Csync Y/G Pb/B Pr/R Y/G Pb/B Pr/R composite s video Y/G Pb/B Pr/R Csync to controller to AVP2
5V DV
1A reg.
WAR N I N G!
Use only with
MADRIGAL
supplied
power supply.
Use only with
MADRIGAL
supplied
power supply.
input 1 input 2 input 3 input 4
input 5 input 6
output
RS-232 control
햷 햹햺햻햶햲 햳 햴 햵 햸
Rear Panel
Please remember to make a note of what sources you connect to which in-
puts. You will need to set up the relationships between front panel buttons
and rear panel connectors later, in the setup menu.
For now, you can connect any component source to any compatible set of
connectors—just keep a list of what-goes-where.
Be careful to connect the multi-wire component connections correctly,
whether YPbPr or RGBCs, as confusing these connections will lead to truly bi-
zarre colors on your display. Nothing can be damaged by this cable confusion.
But if all the colors appear completely fouled up, either: the cables were con-
fused; or the CVP is confused about whether it is handling YPbPr or RGBCs sig-
nals (which are treated quite differently). Careful cable connection now will
make your life a little easier later.
1 COMPONENT INPUT 1
Component Input 1 includes four BNC connectors, which are commonly
used on professional video sources. It may be used in any of several
ways, as shown in the table below:
Input 1 Output
HDTV YPbPr pass through
HDTV RGBCs pass through
HDTV RGsB pass through
SDTV (interlaced) RGsBRsGsBs or YPbPr
(composite available on C sync)
SDTV (interlaced) YPbPr RsGsBs or YPbPr
(composite available on C sync)
SDTV (interlaced) RGBCs pass through