Specifications

68
control trigger 1 as a switch by placing it in series with an external power source
such as a “wall wart” power supply.
The default settings from the factory are as follows:
• trigger 1 = 12V pulse based on standby/operate toggle
• trigger 2 = 12V level when not in standby (0V when in standby)
The three switches that determine what combination of 5V, 12 V or relay your AVP
uses are located inside your AVP and must be set by a qualified installer.
Warning! There are no user serviceable parts inside the AVP!
If you need one of the internal settings changed to support
your installation, please contact your dealer.
rear ir input menu The infrared remote input jack on the rear panel of the AVP may be pro-
grammed to respond to either local commands (e.g., duplicating the functionality
of the IR receiver in the AVP’s main display) or remote commands (e.g. , from an
IR repeater, to affect only the remote signal path). (Refer to the Remote IR and
Remote Turn-on section of your AVP manual for more information.)
The factory default setting is remote. If your installation of the AVP prevents IR
commands from reaching the AVP (as when behind closed doors, for example),
and if you are using an IR repeater to pass IR commands to the system, you may
wish to set the IR input on the rear panel to local, in which case you would also
want to “hard-wire” the AVP to your IR repeater. To make this software change,
follow these steps:
1 ENTER THE CUSTOM MENU
This menu is accessed from the main menu by moving the cursor to
custom, and pressing enter to select the menu item.
2 SELECT REAR IR INPUT
Using the volume ± buttons, move the cursor to rear IR input and press
enter.
3 TOGGLE THE MENU ITEM FROM REMOTE TO LOCAL
Press either of the volume ± keys to change the default setting of remote to
local. Press enter to save the change.