Specifications

49
CD-AUDIO INPUT 1
AUDIO: DIGITAL
CONN: DIGITAL 1
2 PRESS ENTER AGAIN TO WORK WITH “AUDIO:” AND CYCLE THROUGH
YOUR OPTIONS WITH THE VOLUME BUTTONS; CHOOSE DIGITAL AND
PRESS ENTER TO SAVE
Once again, this is the factory default setting. Were you setting up a CD
player that had only analog outputs, though, you would want to change this
to
analog and use a set of analog connectors on the AVP instead.
3 MOVE TO “CONN:” WITH THE VOLUME BUTTONS, PRESS ENTER TO WORK
WITH IT, AND CYCLE THROUGH THE LIST OF CONNECTORS UNTIL YOU
SEE THE ONE YOU USED; PRESS ENTER TO SAVE THIS SETTING, AND
MENU TO RETURN TO THE PREVIOUS/HIGHER MENU
As mentioned during the Quick Start for CD, you can connect any source
component to any appropriate connector, and then simply tell the system
what you have done. It is helpful to have written down what components
are connected where during initial hookup, so you don’t have to try to peer
around the back of the system with a flashlight later. A form for this pur-
pose is included at the back of this manual. (Use a pencil, in case some-
thing changes in the future.)
example: setting up
a laserdisc player
As mentioned earlier, a laserdisc player has several more connections that must
be accommodated than does a simple CD transport. We will run through these
additional settings next, without repeating the sections that remain the same.
VCR2/DISC2 AUDIO CONNECTORS
AUDIO CONNECTORS: 3
1: DIGITAL 3 RF
2: DIGITAL 2
3: ANALOG 2
INPUT OFFSET: 0.0
DEFINE BUTTON VCR2/DISC2
NAME: LD
TYPE: A/V
VIDEO: COMPOSITE 4
MODE: PRO LOGIC + THX
RECORD DEVICE: NO
AUDIO CONNECTORS
(As a reminder, the path to the define button vcr 2/disc 2 menu shown above is
main menu/setup/set source buttons/vcr 2/disc 2—but you can get there faster
by pressing and holding the vcr 2/disc 2 button for several seconds.)
defining the video connection The appropriate type: from the define button vcr 2/disc 2 menu this time is a/v.
After having changed type: to a/v and saved the change, you will see an addi-
tional item immediately below type. The video: item establishes which video
connector you wish to associate with a particular button.
1 MOVE TO THE “VIDEO:” ITEM IN THE MENU, PRESS THE ENTER BUTTON
The arrow cursor will change to the “change-it” cursor (
→
).
2 CYCLE THROUGH THE AVAILABLE INPUTS UNTIL YOU SEE THE ONE YOU
USED WHEN HOOKING UP YOUR LASERDISC PLAYER
The AVP will cycle through the entire list of available video inputs.