Specifications

39
comes available again. (This example assumes you have the optional RF demodu-
lator, of course.)
migrating to analog If the automatic migration feature moves to an analog connection, it will stay
there until you either force a manual migration (see below) or select a different
input. This is due to the fact that the hardware that would normally be detecting
a restored digital signal is already fully occupied receiving your analog signal af-
ter it has been converted to digital. With most laserdisc players, this is not a prob-
lem; nor is it a problem with other sources, whose digital outputs are always
available. However, certain combination DVD/laserdisc players mute their digital
outputs when in pause or stop, forcing the AVP to “look elsewhere” for a usable
signal.
In these cases, it is generally best to set up a separate button (perhaps a
more
button) dedicated to the analog connection form these combi players. Ordinarily,
you would use this connection only when playing old laserdisc that had only
analog soundtracks.
There are three possible settings for automatic migration:
• visible: auto-migrates (displays on screen notices when it does so)
• on: auto-migrates (without any on screen notices)
• off: no auto-migration (forced/manual migration only; see below)
If you choose to turn off automatic migration in this section of the operate menu,
you will have to cycle among multiple inputs manually by pressing the front
panel input button repeatedly.
forced/manual migration Additionally, even when auto migration is set to either on or visible, you can al-
ways temporarily engage manual migration simply by pushing the same input
button repeatedly (which cycles through the connections associated with that
button). As soon as you select any other input button, automatic migration will
reengage.
Important Note: Even with automatic migration on and/or visible, once you
force a “manual” migration by re-selecting the same input
button, the AVP has no way of knowing when you would like to
return to automatic migration. Thus, it automatic migration will
remain off until you change inputs, when it reverts to the
preference you established in the Operate Menu.
setup: locked/unlocked Once the AVP is completely setup, calibrated and ready to go, you may want to
change this setting from setup: unlocked to setup: locked to make it more diffi-
cult to accidently disturb the carefully calibrated settings in the Setup and Custom
Menus. Toggle the lock on and off by moving the “select-it” cursor to this item,
changing to the “change-it” cursor by pressing enter, and pressing either volume
+
or volume – (with only two settings, either plus or minus will work). Then save
your change by pressing enter.